- Joined
- Nov 22, 2017
- Messages
- 77
- Reactions
- 20
- Age
- 64
Hello, I have been planning Waypoints Missions ever since I began with the DJI Phantom 3 Standard, so I am not unfamiliar with how to set up a waypoints mission.
So I decided to test my new DJI Air 3 (AGAIN) and plotted my course on the map preflight. I had 5 waypoints and in settings where you can choose HOVER, RTH, LAND, or BACK TO START, I selected BACK TO START. On settings its shows: BACK TO START/END OF FLIGHT. I had done an earlier test a couple days earlier--very short--and choose BACK TO START and it performed as expected.
However on my latest waypoint flight, It followed all of the waypoints until reaching waypoint #5 and just HOVERED there. I waited and it stayed in place. I finally enabled RTH manually and it returned. I checked the settings in the Waypoint flight and it still said BACK TO START.
Any thoughts on what may have happened? I never lost signal and as far as I can tell the waypoint flight worked fine until reaching the end of the flight.
THANKS FOR YOUR INSIGHT.
So I decided to test my new DJI Air 3 (AGAIN) and plotted my course on the map preflight. I had 5 waypoints and in settings where you can choose HOVER, RTH, LAND, or BACK TO START, I selected BACK TO START. On settings its shows: BACK TO START/END OF FLIGHT. I had done an earlier test a couple days earlier--very short--and choose BACK TO START and it performed as expected.
However on my latest waypoint flight, It followed all of the waypoints until reaching waypoint #5 and just HOVERED there. I waited and it stayed in place. I finally enabled RTH manually and it returned. I checked the settings in the Waypoint flight and it still said BACK TO START.
Any thoughts on what may have happened? I never lost signal and as far as I can tell the waypoint flight worked fine until reaching the end of the flight.
THANKS FOR YOUR INSIGHT.